Platinum Mini Split System
SKU: PSMINI-BP
Platinum Mini Split System
Platinum Mini Split System
Platinum Mini Split System
Platinum Mini Split System
Platinum Mini Split System
Platinum Mini Split System
Platinum Mini Split System
Platinum Mini Split System
Platinum Mini Split System

Platinum Mini Split System

SKU: PSMINI-BP
Regular price
Price :
$6,769.00
/
Est. ship date
Need Help? Call and Talk to an Expert Now

Description

The Mini Platinum Split wine cellar cooling system was designed for a more aesthetic install for smaller wine cellars. Described in the simplest terms, a split system is a cooling unit wherein the evaporator unit and condensing unit have been “split” into two separate units instead of being contained within the same housing. The evaporator unit is located in or near your cellar, and the condensing unit is generally located outside, or in an attic or utility room. The Platinum Split allows you to decide where the evaporator unit and the condensing unit will be located. The condensing unit can be located up to 100 ft. away from the evaporator unit. The evaporator unit will be mounted in the cellar or it can also be located nearby with ducting. If you don’t mind seeing the grille of your cooling unit in your wine cellar, a wall-mounted split system is what you need. If you prefer your unit to be out of sight, you should get a fully ducted split system. The choice is yours. Note: WhisperKOOL does not provide a smart thermostat. By selecting the 24V Thermostat Conversion Kit, you have acknowledged that the system will not be built with the standard WhisperKOOL control or liquid measuring bottle probe. You will have to source and purchase your own 24V smart thermostat to run the equipment. The WhisperKOOL Customer Satisfaction Team does not provide technical support for smart thermostats.

Features:

  • Quiet and efficient operation
  • Advanced electronic control system
  • 2-speed fan switch to adjust BTU/h capacity
  • Condensing unit can be placed outdoors with purchase of exterior housing
  • KDT digital controller/thermostat with a 50-ft. cable
  • 220V high-efficiency (H.E.) condenser

Additional Information

*This unit can cool up to 500 cu. ft. when the cellar is fully insulated and sealed with a proper vapor barrier. Each wine cellar is unique and has specific cooling requirements. Heat load calculations should always be performed prior to selecting a cooling unit.

**The BTU/h value range shown here is a theoretical number. There are often circumstances under which a cellar design may require a larger unit due to variables not accounted for in the formula. For example, these variables could be building materials (such as glass, stone, concrete, etc.) which do not offer the insulation capacity required to maintain the optimal cellar environment. We recommend purchasing a unit with a larger capacity to compensate for these unaccounted-for variables. An undersized unit can lead to premature failure and will most likely prevent the cellar from reaching your desired temperature.

A Cold Weather Start Kit comes standard in every split system. Split systems can be installed in a variety of ways, and the condensing unit may be located in a mechanical room, basement, backyard, or even a rooftop. The condensing units which WhisperKOOL units use were designed to operate between temperatures of 20°F and 110°F. However, there are some areas in the country which may drop below 20°F in winter. When outside temperatures drop, the pressure in the system drops as well. This presents a challenge, because our systems operate using a pump down cycle and use a low-pressure switch to turn the compressor on and off. However, when the temperature drops below 20°F, the pressure in the system is too low to start the compressor. The cold weather start kit bypasses the low-pressure switch on startup and uses heaters installed on the receiver to raise the pressure and allow the system to start.

The Cold Weather Start Kit enables WhisperKOOL to operate in environments as cold as -20°F.

It is important that the cooling system stays operational during cold weather conditions, as heating the house using the central HVAC system will indirectly increase the temperature of the wine cellar. This kit will ensure that the cooling system will continue to operate efficiently in cold weather environments to maintain an optimal wine storage temperature.

Note: 

  • A qualified HVAC-R technician is required for installation. Failure to have the system installed by a qualified technician will void the warranty.
  • The use of the 24-volt thermostat conversion kit eliminates the thermostat normally included with the system and allows your contractor to select, purchase and install the thermostat technology of your choice, including but not limited to Nest, Ecobee, and Honeywell. By selecting the 24V Thermostat Conversion Kit, you have acknowledged that the system will not be built with the standard WhisperKOOL control or liquid measuring bottle probe. You will have to source and purchase your own 24V thermostat to run the equipment.

Why WhisperKool™?

Wine Cooling Systems

Selecting The Right Cooling Unit Is Important

Get A Free Cooling Consultation

Connect With A Cooling Specialist

Complimentary Wine Cellar Design Services

Do You Need Help Designing Your Wine Cellar?

Start Your Free Wine Cellar Design
You may also like